Water-Repellent Sealer

Aquatic Shield is a water-based water-repellent sealer specifically designed for concrete, brick, natural stone and masonry. Aquatic Shield works better and lasts much longer than conventional sealers because it chemically reacts with the substrate to form an insoluble, water-repellent barrier. This barrier is within the surface so it cannot wear away, fade, yellow, crack or peel. The finished application enhances the surface’s natural colour still allowing breathability.

AREA OF USES

• Long service life translates into low overall cost
• Easy to apply
• Fast drying and low odour
• Excellent penetration
• Breathable - excellent vapour transmission
• No change of surface gloss
• No Change of surface colour
• Contains no organic solvents

SUBSTRATES

Concrete, masonry, cement rendering, and natural stones.

BENEFITS

• Excellent water repellence
• Water-based; eliminates the safety concerns related to flammability, fumes and toxicity
• Can be used for outdoor or indoor and enclosed
• Applications with minimal odour
• Excellent moisture vapour transmission (breathability) means 
• Aquatic Shield will not contribute to condensation problems
• Helps to protect reinforcing steel from corrosion
• Resists acid rain and other chemicals
• Resists mildew and moss formation
• Easy clean-up with water

SHELF LIFE / STORAGE CONDITIONS

24 months from date of production.

The product must be stored as per local storage regulations and should be kept in dry and well-ventilated location far from heat and direct sunlight.

AVAILABILITY

Available in 5 litre, 20 kg (Plastic cans)

(Packing may vary from country to country depending on local requirements)

PHYSICAL CONSTANTS

APPLICATION DETAILS

APPLICATION

For professional use only. Surface must be clean, dry and free from traces of dirt, grease, oil, dust, organic growth and any other contaminate that may interfere with the penetration or reaction of the Aquatic Shield. Surface temperatures must be above 40°F/4°C and remain above 40°F/4°C for a minimum of 24 hours. Use as supplied. Do not dilute with water or any other solvents. Always apply a test patch in an inconspicuous area and confirm the results are acceptable for continuing. Use this test patch to determine adequate coverage levels. Protect greenery from over spray.

Aquatic Shield is best applied with a low pressure sprayer. A common garden sprayer is adequate for most jobs. Airless spray equipment is more efficient for larger projects. Can also be applied by mop, flooding and squeegee, broom, brush or roller. Apply two coats at the recommended rates of coverage. Do not allow product to pool on the substrate surface.

IMPORTANT: treated surfaces will begin to develop water repellence soon after the initial application of Aquatic Shield has dried. Since Aquatic Shield is water- based it is necessary to apply the second coat immediately after the first coat is dry, so that the second coat will not be repelled by the first. This may mean that large projects will need to be completed in sections.

APPLICATION CONDITIONS

Use only where application and drying can proceed at temperatures above 5oC, and relative humidity is below 75%. Apply only on a dry and clean surface.

LIMITATIONS

• Not effective on non-silica substrates; do not use on vinyl, asphalt, metals and painted or sealed surface
• Maximum water resistance will be attained once the chemical reaction is complete, typically 4-7 days.
• Limited repellence to oil.
• Not recommended for constant immersion.
• Over coating with paints or sealers is not recommended.

SAFETY

Handle with care. Before and during use, observe all safety labels on packaging and paint containers, consult Hayperflex material safety data sheets and follow all local or national safety regulations. Avoid inhalation, avoid contact with skin and eyes and do not swallow. Take precautions against possible risks of fire or explosions as well as protection of the environment. Apply only in well-ventilated areas.