Transparent Epoxy Coating

Clear EPOXY is a two-component, solvent-free and highly transparent epoxy coating. The product is characterised by being odourless and highly resistant to scratches, abrasions and all kinds of household detergents.

(Two-Component, Solvent-free)

AREA OF USES

• The product can be used in 3D floor coating systems.
• It can be used to protect concrete floors.
• It can be used as a transparent protection coating over marble floors.
• The product can be used as a transparent coating over ceramic in the interior spaces.
• The product can be used in metallic epoxy works by mixing it with colored powders intended for this purpose
• The product can be used in handcraft art works and in epoxy made accessories.
• It can be used as a protection layer over painted and printed artwork

SUBSTRATES

Concrete, Cement surfaces, wood, metal and over 3D pictures for floors.

SHELF LIFE / STORAGE CONDITIONS 24 months from date of production.

The product must be stored as per local storage regulations and should be kept in dry and well-ventilated location far from heat and direct sunlight.

AVAILABILITY

Available in 16 kg metal cans.

(Packing may vary from country to country depending on local requirements)

PHYSICAL CONSTANTS

APPLICATION DETAILS

APPLICATION

Over 3D floors: make sure that you are using the correct kind of printing material that epoxy can stick on it. Clean the surface with warm water using cotton fabric and it is very important to change the fabric every 5 Square meter. Apply one kilo for Square metre to reach 1 mm thickness.

Over decorative metallic and pearl epoxy: make sure that the application takes place during the curing time of metallic and pearl coating and it exceeds that duration. Sanding must be done and then applied to the product.

For use above marble: Be sure to remove the gloss of the marble polish using the available mechanical or chemical means, and then apply one thin coat by roller and after 24 hours apply another coat by squeegee in thickness of 1 mm.

Over Concrete: Remove slip agent and other possible contaminants by emulsion cleaning followed by high pressure hosing with fresh water. Remove scum layer and loose matter to a hard, rough and uniform surface, preferably by abrasive blasting, possibly by other mechanical treatment, flame cleaning or acid etching. Seal surface with T.T Epoxy Sealer SB.

PRECEDING COAT

None

MIXING

Before mixing with the curing agent, stir the base thoroughly in order to prevent any possible settling after storage. After mixing it is equally important to maintain stirring to keep the wet paint as a Homogeneous mixture.

MOISTURE

Epoxy layers should be protected from moisture for 4-6 hours after application. Moisture may whiten the surface or/and make it sticky. It may also disturb hardening. Faded or sticky layers in parts of the surface should be removed by grinding or milling and laid again.

APPLICATION CONDITIONS

Use only where application and drying can proceed at temperatures above 5°C, and relative humidity is below 75%. Apply only on a dry and clean surface.

WEATHERING

The natural tendency of epoxy coatings to chalk in outdoor exposure.

SAFETY

Handle with care. Before and during use, observe all safety labels on packaging and paint containers, consult Hayperflex material safety data sheets and follow all local or national safety regulations. Avoid inhalation, avoid contact with skin and eyes and do not swallow. Take precautions against possible risks of fire or explosions as well as protection of the environment. Apply only in well-ventilated areas.