Microporous Masonry Coating

T 600 is a high performance, water based microporous masonry coating, designed for exterior application affording excellent flexibility and weather resistance. The product is ideally suited   for   the protection   of   exterior   masonry, roughcast, pebbledash, brickwork, cement and concrete rendered surfaces. It can be applied to previously painted surfaces after suitable preparation. This modified acrylic blend is a flexible microporous protective coating that will flex with the substrate where movement causes cracking in conventional masonry paint.

AREA OF USES

• Protection of external masonry walls.
• Protection of roughcast
• Pebble-dash
• Brickwork
• Cement
• Concrete rendered surfaces
• Previously painted surfaces

SHELF LIFE / STORAGE CONDITIONS

24 months from date of production.

The product must be stored as per local storage regulations and should be kept in dry and well-ventilated location far from heat and direct sunlight.

AVAILABILITY

Available in 18 kg (Plastic can)

(Packing may vary from country to country depending on local requirements)

PHYSICAL CONSTANTS

APPLICATION DETAILS

SURFACE PREPARATION

The surface should be stable, firm, dry and free from dust, sand, loose old paint, laitance, dirt, grease and oil. It is recommended to apply a primer/sealer prior to the specified filling procedure. Touch-up with primer/sealer on areas repaired with filler is recommended prior to application of topcoats.

PRECEDING COAT

T.T Concentrated Primer

CLEANING

Clean all equipment and tools with water immediately after use.

SAFETY

For information and advice on the safe handling, storage and disposal of chemical products, users should refer to the most recent Material Safety Data Sheet containing physical, ecological, toxicological and other safety-related data.

REMARK

• All technical data stated in this Product Data Sheet are based on laboratory tests. Actual values may vary due to circumstances beyond our controls.
• This product is not suitable for waterproofing in ponds or areas with pressurized water.
• Newly applied material should not be exposed to rain and frost for 24 hours.
• It should not be used in rainy and fog weather under + 5 ° C.