Epoxy Paint

Epoxy Paint SF, a solvent-free, two-component, high-build, polyamine cured epoxy paint, which cures to a coating with good resistance to fresh water, seawater, crude oil, and to abrasion. Applicable in thick coats by standard heavy-duty airless spray equipment.

(Two-Component, Solvent-free)

AREA OF USES

The product is specially designed for a wide range of heavy-duty use, with various levels of mechanical and chemical exposure.

• Indoor walls and ceiling in heavy-duty factories.

• As a high-build coating for the protection of the exterior of steel pipes, valves, fittings etc. operating at elevated temperatures in severely corrosive environments.

• As a hygienic surface in hospitals, laboratories, food factories, schools and utilities

  
  

SUBSTRATES

Concrete, Cement surfaces, metal and Fiberglass Surfaces.

SHELF LIFE / STORAGE CONDITIONS

24 months from date of production.

The product must be stored as per local storage regulations and should be kept in dry and well-ventilated location far from heat and direct sunlight.

AVAILABILITY

Available in 20 kg (Metal cans)

(Packing may vary from country to country depending on local requirements)

PHYSICAL CONSTANTS

APPLICATION DETAILS

(Working time for epoxy systems decreases when ambient temperature rises)

APPLICATION

Concrete: Remove slip agent and other possible contaminants by emulsion washing followed by high pressure hosing with fresh water. Remove scum layer and loose matter to a hard, rough and uniform surface, preferably by abrasive blasting, possibly by other mechanical treatment or acid etching. Seal surface with Hayper SF epoxy sealer, as per relevant painting specification.

Over Ceramic surfaces: the surface of ceramic must be sanded and the glaze surface must be removed and make sure the surface after that is clean, dry and free from oils or grease.

Metal Surfaces: Metal surfaces must be free from oil, grease and any kinds of liquids. Also the surfaces must be sandblasted to reach to uniform surface then apply one coat of epoxy primer before applying the product.

PRECEDING COAT

Epoxy Sealer SF / Epoxy Sealer SF-MT

MIXING OF THE PAINT

Mix part A for three minutes to make sure that there no settlement in the paint. Pour part B over part A, mix the two parts for 2 - 3 minutes by an electric mixer with low rotation speed (< 300 rpm). After mixing, keep the mix to rest for 1 min before the application.

MOISTURE

Epoxy layers should be protected from moisture for 4-6 hours after application. Moisture may whiten the surface or/and make it sticky. It may also disturb hardening. Faded or sticky layers in parts of the surface should be removed by grinding or milling and laid again.

APPLICATION CONDITIONS

Use only where application and drying can proceed at temperatures above 5°C, and relative humidity is below 75%. Apply only on a dry and clean surface.

WEATHERING

The natural tendency of epoxy coatings to chalk in outdoor exposure.

SAFETY

Application should be done in a ventilated area away from any heat source. Wear protective gear for hands and eyes and avoid breathing of vapour. If mixed resin comes into contact with the skin, it should be promptly removed before hardening, followed by thoroughly washing the skin with soap and water. In case of heavy vapour inhalation, place affected person in an open-air area.

In case of contact with eyes, wash thoroughly with clean water. If swallowed, do not induce vomiting. In all cases, seek medical attention. In case of fire, use CO2 foam to extinguish. Tightly seal containers when not in use, store them away from heat and carefully dispose empty ones