Epoxy Clear Coat

Epoxy Sealer SB is a low viscosity, two-pack epoxy clear coat with good penetration properties. The product have excellent properties in dust proofing, abrasion resistance, chemical resistance, and superior adhesion on porous surfaces.

(Two-Component)

RECOMMENDED USES
For sealing of well cleaned concrete surfaces before application of pigmented paints. Must be applied in such an amount that the surface is just saturated.

SHELF LIFE / STORAGE CONDITIONS
24 months from date of production.

The product must be stored as per local storage regulations and should be kept in dry and well-ventilated location far from heat and direct sunlight.

AVAILABILITY

Available in 20 kg metal cans.

(Packing may vary from country to country depending on local requirements)

PHYSICAL CONSTANTS

APPLICATION DETAILS

APPLICATION

Apply smoothly to the base surface using a roller, etc. after evenly mixing the base and hardener.

SURFACE PREPARATION

Cure concrete for at least 28 days at a temperature of 21? and a relative humidity of 50% For Site Instruction. Completely remove the oil, moisture, sand, dust, laitance and other foreign matter from the surface and maintain surface smoothness. Reinforce cracks, crevices, and joints between walls and floors with an epoxy putty after primer.

Remove slip agent and other possible contaminants by emulsion washing followed by high pressure hosing with fresh water. Remove scum layer and loose matter to a hard, rough and uniform surface, preferably by abrasive blasting, possibly by other mechanical treatment or acid etching.

PRECEDING COAT

None

MIXING THE PRODUCT

A and B component should be mixed with a low speed mixer for at least 3-4 minutes until a homogenous mixture is obtained by paying attention to mixture ratios. It is ready for application after mixing.

CLEANING

Clean all equipment and tools with strong solvent immediately after use

APPLICATION CONDITIONS

Use only where application and drying can proceed at temperatures above 5°C, and relative humidity is below 75%. Apply only on a dry and clean surface.

REMARK

• All technical data stated in this Product Data Sheet are based on laboratory tests. Actual values may vary due to circumstances beyond our controls.
• The proportion of volatile organic matter in the product is relatively high, so the product must be applied in a well-ventilated place.
• Newly applied material should not be exposed to rain and frost for 24 hours.
• It should not be used in rainy and fog weather under + 5 ° C.

SAFETY

For information and advice on the safe handling, storage and disposal of chemical products, users should refer to the most recent Material Safety Data Sheet containing physical, ecological, toxicological and other safety-related data.