Aggregate-filled System

It is decorative, durable aggregate-filled system. This is a complete system which includes epoxy primer, pebble rock aggregate, or grinded glass or any natural material), special binder and a protective clear coat. It provides a slip and impact resistant surface with exceptional strength and wear characteristics. The system has the ability to install over concrete or wood substrates. In addition, it have a variety of aggregate colours may be blended to match any décor.

AREA OF USES

• Auto Dealer Showrooms
• Restaurants
• Office Building Lobbies
• Hallways & offices
• Office Building Common Areas & Workrooms
• Furniture Stores
• Retail Stores& grocery Stores
• Stairways
• Airports
• School Lobbies and Hallways
• Swimming Pool Decks
• Hot Tub / Jacuzzi Decks, Bathrooms, Showers…. Etc.

SUBSTRATES

Concrete and wood surfaces.

SHELF LIFE / STORAGE CONDITIONS

24 months from date of production.

The product must be stored as per local storage regulations and should be kept in dry and well-ventilated location far from heat and direct sunlight.

AVAILABILITY

Available in 21 kg set (Metal cans)

(Packing may vary from country to country depending on local requirements)

PHYSICAL CONSTANTS

APPLICATION DETAILS

SURFACE PREPARATION

Concrete: Concrete must be clean, dry and free of grease, paint, oil, dust, curing agents, or any foreign material that will prevent proper adhesion. The concrete should be porous and be able to absorb water. A minimum of 30 days cure is required on all concrete. Relative humidity in the concrete floor slab should be below 80%. Concrete surfaces shall be bead blasted or diamond grinded to remove all surface contaminants and laitance. Cracks should be chased with a diamond crack chaser (approximately ¼” x ¼”), swept, vacuumed or blown clean and filled with Hayperflex Epoxy Filler or Hayperflex Epoxy Mortar.

Then full coat of Epoxy Sealer -SF should be applied with stainless steel trowel. Then mix the pebble aggregates with the binder and spread by stainless steel trowel and after drying, apply one coat of Hyglass by roll.

PRECEDING COAT

Epoxy Sealer –SF- or Epoxy Sealer SF-MT

MOISTURE

Layers should be protected from moisture for 4-6 hours after application. Moisture may whiten the surface or/and make it sticky. It may also disturb hardening. Faded or sticky layers in parts of the surface should be removed by grinding or milling and laid again.

APPLICATION CONDITIONS

Use only where application and drying can proceed at temperatures above: 10°C/50°F. The temperature of paint itself should be 15°C/59°F or above. Apply only on a dry and clean surface with a Temperature above the dew point to avoid condensation. In confined spaces, provide adequate ventilation during application and drying.

CLEANING

Clean all equipment and tools with strong solven.t immediately after use.

SAFETY

For information and advice on the safe handling, storage and disposal of chemical products, users should refer to the most recent Material Safety Data

Sheet containing physical, ecological, toxicological and other safety-related data.

REMARK

• All technical data stated in this Product Data Sheet are based on laboratory tests. Actual values may vary due to circumstances beyond our controls.
• Newly applied material should not be exposed to rain and frost for 24 hours.
• It should not be used in rainy and fog weather under + 5 ° C.